Mechanical gasoline injection system CIS

  1. Additional designations for models and components
  2. Summary of models and components
  3. Vehicle features
  4. Influencing variables of mechanical/electronic mixture adaptation
  5. Function diagram KE injection
  6. Testing electrical components of the KE injection system
  7. Wiring diagrams
  8. Retrofitting second fuel pump, model 124.026/030
  9. Testing, adjusting engine
  10. Testing kickdown switch
  11. Testing engine output and exhaust emission on the roller
  12. Determining fuel consumption by driving on the road
  13. Testing fuel pressures and internal leaktightness
  14. Testing restrictor in fuel distributor for clear passage
  15. Testing starting valve actuation
  16. Performing fuel quantity comparison measurement
  17. Replacing seal for control plunger
  18. Replacing, centering air flow sensor plate and checking, adjusting
  19. Removing and installing mixture control unit with air guide
  20. Replacing fuel distributor
  21. Removing and installing fuel accumulator
  22. Replacing air flow sensor
  23. Replacing, adjusting throttle valve switch
  24. Replacing electrohydraulic actuator
  25. Removing and installing KE control unit
  26. Testing electronic idle speed control
  27. Testing, adjusting idle speed or special exhaust emissions test
  28. Performing cold start
  29. Testing starting device
  30. Testing on/off ratio as of 1986
  31. Replacing oxygen sensor
  32. Removing and installing fuel filter
  33. Testing fuel pump
  34. Removing and installing fuel pump
  35. Removing and installing fuel pump set
  36. Testing fuel pump relays (except engine 103.984 and as of
  37. Replacing non-return valve for fuel pump
  38. Replacing rubber rings or rubber stop for fuel pump set
  39. Removing and installing throttle valve body
  40. Testing injection valves
  41. Removing and installing injection valves