Replacing oxygen sensor

WIS 07.3-5303

Replacing oxygen sensor – rysunek
Replacing oxygen sensor – rysunek

Operation no. of operation texts and work units or standard texts and flat rates: 07-5303.

Plug connection of oxygen sensor heating coil (G3/2×1) and plug connection of oxygen sensor signal (G3/2×2) (arrow) ………..0.-2005separate in passenger compartment, fit together. Pay attention to note for model 129. Cable of oxygen sensor with rubber grommet … press to outside from passenger compartment, insert.

Installation note

Ensure rubber grommet is correctly seated in transmission tunnel. Splash water plate …………….00008. pull off, fit on.

Installation note

Install heat transmission plate with the opening to the rear. Oxygen sensor 0.0022. 0 eee ee eee unscrew, install. Tightening torque: 50–60 Nm.

Installation note

Coat thread with paste 000 989 76 51. Lambda control 2.2… 0.0.0.0… 00 ee eee eee test, adjust (07.3-2053 or @s4) 07.3-5203).

wim RA 07.3.1132-5303/1

Replacing oxygen sensor – rysunek

Model 129

The 3-pin oxygen sensor plug connection (G3/2×1) is located on the outside right at the transmission tunnel.

Note Slackening union nut = turn counter-clockwise. Tightenint union nut = turn clockwise.

Replacing oxygen sensor – rysunek

Models 107, 126 In right footwell below floor plate.

G3/2 x1 Plug connection, oxygen sensor heating coil G3/2 x2 Plug connection, oxygen sensor signal

Note re model 124

On all vehicles of model 124 with M103, the oxygen sensor with the identification OS 0002 can be installed when retrofitting RUF vehicles or when replacing the sensor. If the oxygen sensor OS 0001 is stated in the vehicle registration document page 4, para 34, the vehicle owner must also be given a copy of the certificate of the Motor Vehicle Registration Office in addition as a confirmation that the oxygen sensor OS 0002 has been installed (applies to Germany only).

wie RA 07.3.1132-5303/2