Maintenance Manual 1968–1980
Oryginalna instrukcja obsługi okresowej Mercedes-Benz Maintenance Manual – Passenger Cars, Volume 1 (Daimler-Benz AG, stan po uzupełnieniu nr 14 z 1984 roku), odczytana ze skanów. Obejmuje samochody od stycznia 1968: 600 (W100), SL/SLC (W107), W108/W109, W111, W113, „/8” (W114/W115), S-klasę W116 i W123 (do 1980). Każde zadanie obsługowe ma numer jak w kartach przeglądów; warianty dla silników i roczników są w treści zadania. Tekst po angielsku, jak w oryginale.
Introduction and maintenance system
Engine mechanical (groups 00, 03, 05, 13, 18, 20)
- 151 Engine oil and filter change
- 156 Clean supplementary oil filter for hydraulic fan coupling
- 751 Check compression
- 752 Retighten cylinder head bolts
- 753 Adjust valve clearance
- 756 Retension V-belts
- 758 Check condition and retension V-belts
- 759 Slacken engine stop and tighten screws
- 760 Slacken engine stop
- 907 Check hose clamps for tight fit
- 990 Check and correct coolant level
- 991 Renew coolant with corrosion antifreeze protection
Fuel, air intake, exhaust (groups 07, 09, 47, 49)
- 041 Fuel system, check sealing and condition
- 101 Check and correct fluid level in oil bath air filter
- 202 Clean air filter element
- 203 Replace air filter element
- 205 Oil bath air filter, clean
- 415 Lubricate engine control linkages and control shafts
- 762 Clean flame guard filament
- 770 Check and adjust ignition timing
- 772 Check and adjust ignition timing
- 773 Renew contact breaker points
- 781 Check dwell angle
- 782 Adjust dwell angle and ignition timing
- 787 Check begin of delivery
- 788 Check oil level in damper of Stromberg carburetor
- 797 Check and adjust idle speed adjustment
- 798 Check and adjust idle speed
- 800 Check and adjust oil level in injection pump
- 806 Replace filter of auxiliary air valve of the injection pump
- 813 Engine control linkages, check
- 832 Check condition of ignition system / evaluate oscillograph picture
- 840 Replace fuel filter or filter element
- 844 Fuel prefilter, check
- 845 Fuel main filter, clean or replace
- 847 Fuel filter, clean or replace
- 849 Replace fuel filter element
- 871 Check intake and exhaust manifolds and exhaust flange
- 876 Retighten carburetor flange
- 877 Tighten fastening nuts on exhaust gas turbocharger
- 891 Check fuel pipes and hoses of the electronically controlled gasoline injection
- 951 Retighten exhaust system slip joints
Clutch (group 25)
Manual transmission (group 26)
Automatic transmission (group 27)
Suspension (group 32)
- 020 Hydro-pneumatic suspension – check rubber sleeves of ball joints
- 085 Check sealing and condition of level control system
- 086 Hydro-pneumatic suspension – check system for leaks
- 087 Check condition of air suspension system
- 138 Check and correct fluid level in level control system
- 139 Hydro-pneumatic suspension – check and correct fluid level
- 466 Drain condensation from air reservoir of air suspension
- 470 Renew air filter of air suspension system
- 622 Check level of vehicles with air suspension (position of wishbone arms)
- 628 Hydro-pneumatic suspension – check pressure reservoir and central reservoir for gas filling pressure
- 676 Check air bellows of air suspension system
- 902 Retighten fixing bolts of the air compressor
Front axle (group 33)
Rear axle (group 35)
Wheels and wheel alignment (group 40)
Propeller shaft (group 41)
Brakes (group 42)
- 009 Check brake cables for ease of movement
- 097 Brake test on test bench/Test drive
- 700 Check and correct fluid level in the brake system
- 701 Bleeding brake system
- 702 Renew brake fluid
- 704 Checking oil level in vacuum pump
- 706 Adjust parking brake
- 711 Front wheel brake – visual check of brake pads
- 712 Check, clean brake discs while removing brake pads
- 713 Clean ventilation bores on the compressed air brake booster
- 714 Brake lines, check for damage