Removal and installation of immersion tube indicator
47—710 Removal and installation of immersion tube indicator A. Model 116 Tightening torque Nm Immersion tube indicator 35-43 Removal 1 Remove first aid kit and first aid kit mounting shell (arrow).…
Removal and installation of fuel expansion tank (model 114)
47—705 Removal and installation of fuel expansion tank Model 123T-sedan Removal 1 Remove spare wheel paneling and spare wheel. Lift spare wheel paneling slightly during removal until pins (arrows) disengage. 2 Unscrew…
Removal and installation of fuel tank
47—700 Removal and installation of fuel tank A. Model 116 ®1978-1980 Filling capacities in liters Full readout approx. 82 Warning lamp — reserve approx. 14 Tightening torques Nm Fastening nuts for fuel…
Removal and installation of accelerator pedal
30—330 Removal and installation of accelerator pedal A. Model 116.120 and model 123.193 1 st version Removal 1 Compress spreader clip (arrow) behind accelerator pedal and pull out. Installation 2 During…
Removal, installation and adjustment of front wall regulating shaft
30—320 Removal, installation and adjustment of front wall regulating shaft A. Model 116.120 Adjusting values in mm Length of connecting rod (11) from accelerator pedal to guide lever 122 Length of…
Removal and installation of engine longitudinal regulating shaft
30-310 Removal and installation of engine longitudinal regulating shaft Note When removing transmission, remove longitudinal regulating shaft, so that bearing on front wall is not damaged by tilting of engine. A. Model…
Adjusting throttle linkage
30-300 Adjusting throttle linkage A. Model 123.193 standard version 1st version Length of regulating rods in mm Free travel rod (13) in pulled out condition 154 Connecting rod (14) 140 Pushrod…
Removal and installation of engine shock absorber
22—240 Removal and installation of engine shock absorber Note Model 116.120 The engine has two engine shock absorbers, which are mounted at the left and right between engine carrier and frame cross member.…
Adjusting engine stop – Model 123.193
22-220 Adjusting engine stop – Mode! 123.193 Tightening torque Nm Adjusting screw (11) on rear engine mount 40 Special tool Torque wrench with plug-in ratchet, 1/2″ square, 25-130 Nm 001 589…
Removal and installation of rear engine mount
22—212 Removal and installation of rear engine mount Tightening torques Nm Screws for engine mount on engine carrier 30 Adjusting screw for engine mount (model 123.193) 40 Special tools …