751 Check compression

Revision: Revised. All gasoline engines

Test values with warm engine Pressure in bar (atu)

Standard compression rox.85 and @s@ up to 1971 ape Minimum compression?) — with starting 1977 Q ® starting 1976 approx. 7.5 Low compression and usa) starting 1972

Permissible difference between individual cylinders max. 1.5

1 oo oe ) Check cylinders for leaks when compression is below minimum.

751 Check compression – rysunek

Special tool

751 Check compression – rysunek

Rotating engines

Rotate engines with starting motor and contact handle: For this purpose, connect contact handle as follows:

Models 114 and 115

Connect contact handle to battery + and to starter terminal 50.

Disconnect cable at ignition coil terminal 1.

Models 107 and 116

Engines with carburetor and electronic injection system

Connect contact handle to battery + and to starter terminal 50.

Disconnect cable on ignition coil terminal 1.

751 Check compression – rysunek

Engines with cis injection system

Model 107

Switch off ignition. On 4-pole cable connector, disconnect cable terminal 16 (cable color red/purple). Connect contact handle to terminal 30 (cable color red) and terminal 50 (cable color purple).

751 Check compression – rysunek

Model 107

Model 116

Disconnect cable on ignition coil terminal 71. Pull out relay code number 21 for fuel pump of warm-up compensator in fuse box. Connect contact handle to battery + by means of a pin to contact bushing 1 of coupling (arrow).

751 Check compression – rysunek

Model 116

Model 123

Disconnect cable on ignition coil terminal 7. Connect contact handle to terminal 30 and terminal 50 on cable connector. Instead of terminal 30, connection can also be made to battery +.

On models 123.003/026/028/086, connect contact handle to battery + and to starter termina! 50.

Model 123.007/03/05/093

Check compression 15°

751 Check compression – rysunek
751 Check compression – rysunek
751 Check compression – rysunek

On engine with CIS injection system pull off relay code number 21 (3) for fuel pump or warm-up compensator

Checkup

  • Unscrew spark plugs.
  • Crank engine several times in idle speed position with ignition switched off to throw out residue and soot
  • Push compression pressure recorder into spark plug bore of respective cylinder.
  • To check, crank engine for approx. 8 revolutions with throttle valve open.

Check all cylinders in this manner. Put data sheet in compression pressure recorder into new working position first.