501 Check wear on the clutch driven plate

Models 107 108 109 111. starting May 1969 114 115 116 123

Special tool

Gauge – 115 589 07 23 00

501 Check wear on the clutch driven plate – rysunek
  • Push gauge between the clutch bell housing and the slave cylinder as far as possible and pay attention to the notches on the gauge.
  • If the notches are not visible: Driven plate wear is not serious.
  • If the notches are visible: The wear limit of the driven plate has been reached. Exchange driven plate.

1 Slave cylinder 2 Spacer between slave cylinder and clutch housing 4 Gauge

501 Check wear on the clutch driven plate – rysunek

Models 108.016/018/019 from Jan. 1968 109.016 111.024/025 to May 1969 113.044

  • Press the end of the clutch release fork (1) in the direction of the slave cylinder (2) (see arrow).

® if this is possible against a resilient, yielding resistance, the driven plate is still usable.

@ {f the fork end only moves slightly (approx. 2mm), or not at all, towards the slave cylinder, the driven plate is to be replaced.

1 Clutch release fork

2 Slave cylinder

5801/2