Mechanical gasoline injection system CIS

  1. F1 ARO7.03-P-6522D Removing and installing injection valves 9.2.95 (continued)
  2. Location of components
  3. Removing and installing starting valve
  4. Performing fuel quantity comparison measurement
  5. Checking, adjusting zero position of air flow sensor plate
  6. Operation No. of operation texts and work units or standard texts
  7. Replacing seal for contro! plunger
  8. Removing and installing air flow sensor plate
  9. Removing and installing mixture control unit
  10. Removing and installing diaphragm pressure regulator
  11. Removing and installing fuel distributor
  12. Removing and installing fuel
  13. Removing and installing air flow sensor
  14. Removing and installing coolant temperature sensor
  15. Operation No. of operation texts and work units or standard texts
  16. Removing and installing throttle valve switch
  17. Removing and installing microswitch
  18. Removing and installing intake air temperature sensor
  19. Replacing electrohydraulic actuator
  20. Replacing vehicle speed Hall-effect sensor
  21. Removing and installing CIS-E control unit
  22. Removing and installing idle speed motor
  23. Replacing oxygen sensor
  24. Removing and installing fuel filter
  25. o7. 3-5713 Removing and installing fuel pumps
  26. Operation No. of operation texts and work units or standard texts
  27. Replacing check valve for fuel pump
  28. Operation No. of operation texts and work units or standard texts
  29. Preceding work: Operation No. of operation texts and work units or standard texts
  30. Testing injection valves
  31. Removing and installing injection valves