Testing injection valves

WIS 07.3-6500

‘caunnnavoavensnasnaueuaunsanensenasesnennneussuseeesneeeauavecusneunsquaneuensuneeresenasenassusarensusauuustiessudeuranerasenvuuueseuaauensunsurenuensuenuedsennseuasustesnnennnsensndusadeuerseeeneeteneensennedunarensenseenienaasnanenaserss

Testing injection valves – rysunek

Preceding work: Operation No. of operation texts and work units or standard texts Ramoving and installing injection valves (07.3-6520) and flat rates:

Note The chatter test and the assessment of the spray jet do not require to be performed on injection valves with Viton seal seat.

Testing for Jeaks and opening pressure

Injection valve …….. see ee ee bce e weer connect to tester. Pressure line 2… cee eee bleed with shutoff cock open and union nut open. Union nut 2.2… ee ee teens tighten. Rough leak test 2… eee ee ee perform. With shutoff cock open, slowly operate hand lever (approx. 2 s/stroke) and build up pressure to max. 1.5 bar. If a leak is detected at the injection valve, the injection valve must be replaced. Opening pressure …………..0–. sees check. Flush through injection valve by operating hand lever rapidly several times with the shutoff cock closed. Open shutoff cock and check opening pressure with slow movement of hand lever {approx. 2 s/stroke).

aie = RA 07.3.1211-6500/1

Testing injection valves – rysunek

Leak test 2.2… ee ee eee perform. Flush through injection valve by operating hand laver rapidly several times with shutoff cock closed. Open shutoff cock and slowly increase pressure up to 0.5 bar below the opening pressure determined previously, and maintain this pressure. No drop should forrn at the injection valve within 15 seconds.

inection lines to fuel distributor (approx. value) 10 ~ 12 Injection lines to injection valves (approx. value) 10 – 15

Testing injection valves – rysunek

Commercially available tools and testers Designation e. g. Make, Order No.

100 589 13 21 00 is required for testing the injection valves.

Note The tester reservoir must be filled and the unit bled before it is possible to commence the test of the injection valves. Use only kerosene for testing. Replace injection valves which are beyond the tolerance limits. The injection valves can be replaced individually within a set.

ame =A 07.3.1211-6500/2