Removing and installing CIS-E control unit

WIS 07.3-1698

Removing and installing CIS-E control unit – rysunek
Removing and installing CIS-E control unit – rysunek

Operation No. of operation texts and work units or standard texts and flat rates:

Model 129

aie = RA 07.3.1212–1698/1

Accessories compartment cover ………. -. remove, install. Locking bar (arrow) …… wee see eee .. open, close. CIS-E control unit connector .. unplug, plug in. SorewS 2.2… ee ee eee . unscrew, screw in. CIS-E control unit (N3) 6.2… sce eee eee remove, insert.

Notes As a result of a software modification, no fault is displayed anymore when driving at high altitudes.

Removing and installing CIS-E control unit – rysunek

Production breakpoint

Since August 1990 the tuning of the secondary air pump and exhaust gas recirculation has been modified (introduction of end-of-production-line diagnosis).

Removing and installing CIS-E control unit – rysunek

Production breakpoint: August 1990 Model Engine Vehicle Ident Basic National version

gehts = AA 07.3.1212-1698/2

Removing and installing CIS-E control unit – rysunek

Since September 1990 CIS-E control units with Measuring current at the electrohydraulic a modified program have been installed. As a actuator (CIS-E control units up to 09/90): result, the specified value of the current at the When measuring the current at the electrohydraulic actuator is available as soon as electrohydraulic actuator (after switching on the the ignition is switched on without any time ignition), a difference of +/- 13 mA from the delay. respective specification is permissible. The The modified control units can also be installed specification must be achieved after 15 minutes. on vehicles with a lower vehicle ident end no. lf the arnperages are within the specified tolerance, the control unit is operating properly and therefore does not need to be replaced.

Since April 1991 an EZL. ignition control unit The inlet camshaft advance at part load at with modified map and a modified CIS-E control engine speed above 5000 rpm has likewise been reduced from 17 °CA to 14.5 °CA, unit have been installed for the adjustment range of the inlet camshait in order to reduce A, ZN combustion noises. The total adjustment range of the inlet carnshaft The CIS-E control unit must only be installed is reduced to 29 °CA (previously 34 °CA). together with the relevant EZL. ignition control unit.

Production breakpoint: April 1991 (except Gs) Engine end no. Engine end no. Manual transr Automatic transmission

124.031 104.980 005792 025654 124.051 424.091

129.061 104.981 00113 010894

wii = RA 07.9.1212-1698/3