07.5—520 Testing breaker-controlled transistorized ignition (T) (us*   Conventional tools   1 voltmeter, measuring range 0—3 V, 0—15 V with 0.1 V scale graduation   1 ohmmeter, measuring range starting 0.1 ohm   1. Testing…

    07.5—519 General description of breaker-controlled transistorized ignition   Layout of transistorized ignition The system comprises: Switchgear Ignition coil Pre-resistor 0.4 ohm (3) Pre-resistor 0.6 ohm (4) Operation The ignition coil current is controlled by a…

    07.5—510 Removal and installation of ignition distributor   Removal 1    Remove protective cap, distributor cover, cable plug connections and vacuum line. 2   Set engine to ignition TDC of 1st cylinder. For this purpose, the…

    07.5—505 Renewing contact breakers (breaker points)   Closing angle (dwell angle)   Normal coil ignition   Closing angle (dwell angle) Testing and adjusting value at idle1) Change between idle and 3000/min   39-42 max. ±…

    07.5—503 Removing, preventing formation of layer on breaker points (breaker-controlled transistorized ignition)   Conventional tool   Voltmeter with measuring range                               …

    07.5—500 Checking and adjusting closing angle (dwell angle) and firing point   Closing angle (dwell angle)   Normal coil ignition   Closing angle (dwell angle) Testing and adjusting value at idle1) Change between idle and…