Removal and installation of engine longitudinal regulating shaft
|
|
|||
|
30-310 Removal and installation of engine longitudinal regulating shaft
|
|||
|
|
|||
|
Note
|
|||
|
|
|||
|
When removing transmission, remove longitudinal regulating shaft, so that bearing on front wall is not damaged by tilting of engine.
|
|||
|
|
|||
|
A. Model 116.120
|
 |
||
|
Removal
|
|||
|
1 Disconnect regulating rods.
2 Turn longitudinal regulating shaft to the left until groove disengages from clip. Push longitudinal regulating shaft to the rear and remove.
|
|||
|
|
|||
 |
|||
|
|
|||
|
Installation
|
|||
|
|
|||
|
4 For installation proceed vice versa. Grease bearing points as well as ball sockets of regulation with Moly-kote Longterm 2.
5 Adjust throttle linkage (30-300).
|
|||
|
|
|||
|
30.8-310/1 F3
|
|||
|
|
|||
|
|
|||
|
B. Model 123.1
|
 |
||
|
Removal
|
|||
|
1 Remove regulating rod (5) and lock (33).
2 Slide longitudinal regulating shaft in forward direction out of bearing on front wall. Then remove toward the rear.
|
|||
|
|
|||
 |
|||
|
1303″ 996 V1
|
|||
|
|
|||
|
Installation
|
|||
|
|
|||
|
3 For installation proceed vice versa. Grease bearing points as well as ball sockets of regulation with Moly-kote Longterm 2.
4 Adjust throttle linkage (30-300).
|
|||
|
|
|||
|
30.8-310/2 F3
|
|||
|
|
|||
|
|
|||
|
C. Model 126.120
|
 |
||
|
Removal
|
|||
|
1 Disconnect regulating rods (5 and 61).
2 Remove lock (84), corrugated washer (83) and plastic spacing ring (32).
3 Push longitudinal regulating shaft (3) to the rear and remove.
|
|||
|
|
|||
 |
|||
|
|
|||
|
Installation
|
|||
|
|
|||
|
4 For installation proceed vice versa. Grease bearing points as well as ball sockets of regulation with Moly-kote Longterm 2.
5 Adjust throttle linkage (30—300).
|
|||
|
|
|||
|
30.8-310/3 F3
|
|||
|
|
|||