Renewing rear crankshaft radial sealing ring

03—327 Renewing rear crankshaft radial sealing ring


Tightening torques		Nm
Necked-down screw for camshaft gear		80
Connecting rod nuts	initial torque	40-50
Connecting rod nuts	angle of rotation torque	90-100°
Necked-down screws for	initial torque	30-40
flywheel or driven plate	angle of rotation torque	90-100°
Crankshaft bearing bolts		90
Special tool

Angle of rotation tool

116 589 01 13 00

Self-made tool

Gauge for cutting-off rear radial sealing ring

refer to Fig. item 4

Note

The radial sealing ring is graphite gray similar to that in other diesel engines.

Renewing

1 Remove engine (01 -030).

2 Remove crankshaft.

03.8-327/1 F 2



	3 Place radial sealing ring into cylinder crankcase and into oil pan and work in by means of a lubricated hammer handle.

	4 To obtain the required overlap, cut off radial sealing ring in cylinder crankcase and oil pan approx. 1.0 mm above parting surface.

	Dimension a = 1.0 mm

	Z033-400V1

	Note: For cutting-off, a self-made template according to drawing can be used.
	Dimension a = 1.0 mm

	5 Lubricate radial sealing ring prior to installing crankshaft. 6 Install crankshaft. 7 Mount oil pan, rotate crankshaft and check for unobstructed operation.

	03.8-327/2 F 2