Removal and installation of engine shock absorber

Note

The engine has two engine shock absorbers, which are mounted at the left and right between engine carrier and frame cross member.

The engine has two engine shock absorbers, of which the left one is mounted between engine carrier and frame cross member and the right one between engine carrier and console for lower control arm.

The lefthand engine shock absorber is located behind, and the right one in front of engine carrier.

The engine has two engine shock absorbers, which are located at the left and right between engine carrier and frame cross member.

The lefthand engine shock absorber is located behind and the right one in front of engine carrier.

On all models, the engine shock absorbers are fastened to engine carriers by means of an engine damper bear­ing (42) and to frame cross member or console by means of rubber buffers and disk washers.

On model 123, from start of series, rubber buffers with disk washers were temporarily installed on right-hand engine shock absorber instead of damper bearing.

22.8-240/1 F 2

1    Unscrew nuts (40). For unscrewing lower nut, apply counterhold to piston rod at spot provided for this purpose (refer to Fig. item 6).

2    Remove lower disk washer (46) and lower rubber buffer (47).

3    Unscrew engine damper bearing (42).

Engine shock absorber left and right in model 116.120

40    Nut M 6

41    Combination screw M 6 x 15

42    Engine damper bearing 43a Engine carrier

45 Engine shock absorber

46    Disk washer

47    Rubber buffer

48    Frame cross member

4 Remove engine shock absorber.

For this purpose, on model 123, pull righthand engine shock absorber (1st version) out of holder on engine carrier in forward direction.

Engine shock absorber left in model 123

Engine shock absorber right in model 123 (1st version)

40    Nut M 6

41    Disk washer

42    Rubber buffer 43a Engine carrier

45 Engine shock absorber

46    Disk washer

47    Rubber buffer

48a Holder on console for lower control arm

22.8-240/2 F 2

Engine shock absorber right in model 123 (2nd version)

40 Nut M 6

42 Engine damper bearing

43a Engine carrier

45 Engine shock absorber

46    Disk washer

47    Rubber buffer

48a Holder on console for lower control arm

Engine shock absorber left in model 126.120

40 NutM6

42 Engine damper bearing

43a Engine carrier

45 Engine shock absorber

46    Disk washer

47    Rubber buffer

48    Frame cross member

22.8-240/3 F 2

Engine shock absorber right in model 126.120

Installation

5    Insert engine shock absorber with piston rod in downward direction, with upper disk washer (46) and rubber buffer (47).

On model 123 slip righthand engine shock absorber (1st version) from the front on holder on engine carrier. Rubber buffer (42) should be under holder.

6   Slip lower rubber buffer (47) and disk washer (46) on piston rod.

7   Screw-on engine damper bearing (42).

8   Position nuts (40) and tighten.

For tightening lower nuts (40), apply counterhold to piston rod at spot provided for this purpose (arrow).

■S0O-13GSS