Draining and filling coolant – Anti-freeze table

Anti-freeze/water in liters for models Protection down to 107                      114                      116                      123                       126

-20 °C -30 °C -40 °C

Total amount                _u                        „                         „                         _1Q

in liters

‘) see service product specifications on page 325.

²)  see service product specifications on page 310.

³)  add 1 % or 10 cc of anti-corrosion oil/liter to water for model 114, even when using an anti-freeze (see service product specifications on page 311).

M This torque can be established by means of a washer or coin.

Antifreeze tester

Prestone-VU-Check (Union-Carbide)

e.g. made by Philipp Gather, D-4020 Mettmann 2

20.2-010/1 F3

1 Open radiator cap or expansion tank in steps (only below 90 °C) (194 °F).

2 Unscrew radiator drain plug.

Models 107, 114, 116

Model 123

Model 126

12O-TO8?

3 Remove drain plug on right side of engine block behind engine carrier.

20.2-010/2 F3

4   Set both heater levers or temperature dials on model 126 to “/warm” position.

5   Add coolant slowly until level is at mark.

Model 107

6   Run engine warm by intermittent acceleration and keep radiator cap closed as from 70 °C (158 °F) until thermostat opens.

7   Check coolant level and correct to specified level.

Models 114, 116

Model 123, 126

a cold b warm

20.2-010/3 F3