Removal and installation of ignition distributor
|
|
|||
|
15—510 Removal and installation of ignition distributor
|
|||
|
|
|||
|
Note
|
|||
|
|
|||
|
Turn crankshaft in direction of engine rotation at fastening screw of V-belt pulley only.
|
|||
|
|
|||
|
Removal
|
 |
||
|
1 Remove ignition distributor cap, cable plug connections and vacuum lines.
2 Set engine to ignition TDC of 1st cylinder. For this purpose, the markings on the distributor rotor and on distributor housing should be in alignment.
|
|||
|
|
|||
|
3 In addition, the pointer on crankcase should be above TDC mark of vibration damper.
4 Loosen ignition distributor attachment and pull out ignition distributor.
|
 |
||
|
|
|||
|
Installation
|
|||
|
|
|||
|
5 For installation proceed vice versa. Pay special attention to ignition TDC of 1st cylinder and to markings on distributor housing and vibration damper.
6 Adjust firing point (15-501).
|
|||
|
|
|||
|
15.2 lib—510/1 F2
|
|||
|
|
|||