Testing, adjusting idle speed

WIS 07.1-2053

Testing, adjusting idle speed – rysunek

Operation no. of operation texts and work units or standard texts and flat rates:

A Engine 605.911 B Engine 606.910

Digital tester (001), TDC pulse generator (021) .. connect, disconnect. Accelerator control wee eee check for ease of movement. Idle speed stop at Bowden cable (82) ……… check; the dished washer (29/7) must be resting free of tension against the compression spring (29/8). If necessary, adjust Bowden cable from inside car (see 30-1010 Adjusting accelerator contrcl). Engine 2.2… eee ee eee eee seen eee warm up to coolant temperature of 60 — 80 °C.

Engine 605.911 with pneumatic idle speed

increase (PLA)

Idle speed oe eee check; adjust if necessary by turning the vacuum unit (12/3). To do this, slacken lock nut (arrow). Refer to table for test data.

eign = RA 07,1.1621-2053/1

Engine 606.910 with electronic idle speed control (ELR) 2-pin coupling of ELR actuator (Y22)) …….. . unplug, plug in. Idle speed owe ee eee eee check; adjust if necessary. To do this, slacken lock nut (arrow) and turn adjusting bolt (ring wrench). Refer to table for test data.

To the left: higher engine speed To the right: lower engine speed

Testing, adjusting idle speed – rysunek
Testing, adjusting idle speed – rysunek

All models Smooth engine running 2… 6… ee ee check. Operate service brake. Move selector lever into drive position. Switch on AC compressor. Turn power steering to full lock. Engine must continue to run smoothly when this is done.

Digital tester Firrna Bosch, MOT 002.01 Firma Sun, DIT 9000

ahs = RA 07.1.1621-2053/2