Testing cylinders for leaks

WIS 01-0150

Operation no. of operation texts and work units or standard texts and flat rates

Engine cee eee eee eee

warm up to operating temperature. Ground cable at battery …………..4.. disconnect, connect. Spark plugS eee eee eee eee eee remove, install (15-1031). Cap on coolant expansion reservoir …….. open, close.

AN Do not open cap unless coolant temperature is below 90 °C. Risk of scalding! Coolant level 00. cece eee eee eee adjust to correct level (20-0100). Oil filler cap we eee eee open, close. Cylinder leak tester ………….0.00005 connect to compressed air system. Tester 2… ee eee ene calibrate. Connection hose «1… eee eee eee screw in to first spark plug hole, remove. Piston of cylinder to be tested ………… position with adjuster by turning crankshaft to ignition TDC. Piston in ignition TDC ……………4.. see table. Connection hose of tester …………… connect, disconnect. Compression chamber …………50005 pressurise.

AN The crankshaft must not rotate; if necessary secure crankshaft with locking device to prevent it rotating (03-5000). Throttle valve «0… ee eee open by hand. Pressure loss on tester in % ……….06read off. PreSSUre w. e ee eee determine whether leak through intake manifold, exhaust, oil filler opening, spark plug hole of adjacent cylinder or coolant filler opening (at reservoir). Allcylinders 2.0 cee ee eee eee test in firing order (1–5–4–8–6–3–7–2).

lime §=RA 01.1321-0150/1

Data

Total pressure loss max. 25 %

At valves and cylinder head gasket max. 10 %

At pistons and piston rings max. 20 %

Marking index Piston in TDC

0 1 and 6

90 5 and 3

180 4and 7

270 8 and 2

Commercially available tool

Cylinder leak tester Bosch, EFAW 210A Sun, CLT 228

elim = RA 01.1321-0150/2