Cranking engine with starter

WIS 01-0110

A. Model 124.034

Cranking engine with starter – rysunek
Cranking engine with starter – rysunek
Cranking engine with starter – rysunek

PO1-5781–57

Ignition… cc eee ee eee switch off. Cover over engine component compartment …. detach, attach. Cover of terminal block (X4/10) ……….00open, close. Connector (S) of plug connection (X27) ……. unplug, plug in. Crocodile clamp (A) of compression tester at pin 1 of connector ……….0 cece eee eee connect, disconnect, special tool 001 589 77 21 00. Crocodile clamp (B) of compression pressure recorder at the terminal block (X4/10) ……… connect, disconnect. Engine 1… cece eee crank in idle speed position and with parking brake applied by pushing contact handle (arrow) on compression tester.

AN Do not crank engine using ignition starter switch.

imme RA 01.1313-0110/1

Cranking engine with starter – rysunek
Cranking engine with starter – rysunek
Cranking engine with starter – rysunek

P01-5784–57

switch off. Ignition 22… eee eee take off, install. Cover over engine component compartment …. open, close. Cover of terminal block (X4/10) ………46unplug, plug in. Connector (S) of plug connection (X27) …… Adaptor cable (01) with plug connection (X27) … connect, separate, special tool 124 589 36 63 00. Adaptor cabel (01) with cable (02) of compression tester …….–.-+.e cece eens connect, separate, special tool 001 589 77 21 00. connect to terminal block (X4/10, disconnect. Crocodile clamp (B) of compression tester ) crank in idle speed position and with parking Engine 2… cece eee eee ees brake applied by pushing contact handle (arrow) at the compression tester.

A Do not crank engine using ignition starter switch.

aim RA 01.1313-0110/2

Cranking engine with starter – rysunek
Cranking engine with starter – rysunek

Ignition 2… ccc ee ee eee eee eee switch off. Cover over component compartment ……… remove, install. Connector of plug connection (X27) ………. unplug, plug in. Crocodile clamp (A) of compression tester ….. connect at pin 1 of connector (S), disconnect, special tool 001 589 77 21 00. Cover of terminal block (X4/10) …………. open, close. Crocodile clamp (B) of compression ……… connect tester to terminal block (X4/10), disconnect. Engine 26… cece ee ee ee te eee eee crank in idle speed position and with parking brake applied by pushing contact handle (arrow) on compression tester.

Do not crank engine using ignition starter switch.

whim RA 01.1313-0110/3

a we te

D. Typ 140

Cranking engine with starter – rysunek

013 Pulse counter 075 Pulse counter adaptor X11/4 — Test coupling for diagnosis (38-pin)

Left cover over EZL ignition control unit …… take off, fit on. Crankshaft position sensor (L5) at EZL ignition control unit (N1/3) 1.2… eee ee eee unplug, plug in. Engine 220 e eee eee eee eee eee crank in idle speed position and with parking brake applied using ignition starter switch (S2/1). EZL ignition control unit (N1/3) fault memory …. read, erase (see Diagnosis Manual Engine Volume 2, Index 0).

Note If the engine is started with the crankshaft position sensor (L5) unplugged, a fault is stored in the EZL ignition control unit (N1/3) fault memory (contact 17, pulse readout 17). This must be erased after completing the work.

wim RA 01.1313-0110/4

E. Model 210

Cranking engine with starter – rysunek
Cranking engine with starter – rysunek

Preceding work: Hazard warnings when hood opened (01-0085).

P01.10-0263–57

Ignition 6… eee eee ee eee switch off. Cover (2) over engine component compartment . remove, install. Connector of plug connection (X22) (circuit 50) .. unplug, plug in. Clamp of cable (01) «1… ec eee eee eee connect to pin 1 of plug connection (X22) circuit 50, disconnect. Cable (01) 2… cece ee eee eee eee connect to cable (02) of compression recorder, disconnect. Cover of terminal block (X12/8) 2.2.2… 00s open, close. Clamp (03) of compression recorder 001 589 762100 eee ee ee ee eee connect to terminal block (X12/3) circuit 30, disconnect.

tim §=RA 01.1313-0110/5

the compression recorder, transmission in Neutral and parking brake applied.

A Do not crank engine at ignition/starter switch.

Special tools

Cranking engine with starter – rysunek

\

wim RA 01.1313-0110/6