Checking and machining valves
WIS 05-280
Data
| Valve dia. | Intake | 8.955–8.970 | |
| stem | Exhaust | 8.935–8.960 | |
| Valve | Intake | 116.8–117.2 | |
| length | Exhaust | 117.8—-118.2 | |
| Sodium | Intake | without | |
| charge | Exhaust | with | |
| Valve seat plating | Intake Exhaust | with with | |
| When new | Intake | 1.5 | |
| (h) of valve retainer | Exhaust | 2.5 | |
| Height | Limit value | Intake | 1.0 |
| Exhaust | 2.0 | ||
| Adjusting angle (a) for machining of valves | 45° | ||
| Permissible runout on valve stem and valve seat max. | 0.03 | ||
| Permissible runout on face of valve stem when mounted at valve stem | 0.015 | ||
| Conventional tools | Oe | ||
| Valve cone grinding machine or Valve cone turning machine | e.g. Krupp, D—5320 Bad Godesberg Model VS e.g. Hunger, D—8000 Miinchen 55 Type VKDR 1A, order No. 203.00.200 | ||
Note
The exhaust valves are filled with sodium!
When scrapping these valves, observe safety regulations. Do not melt valves filled with sodium as there is a risk of explosion and do not use such valves for making tools (punch etc.) without first removing the sodium filling.
Be careful when removing the sodium from the valves, since sodium mixed with water and watery solutions causes an extremely severe and explosive reaction and the resulting hydrogen gas may start a fire.
Sodium from cut or broken-up valves can be neutralized in a mixture of 2 liters of spirit of alcohol and 1 liter of water in a container in the open air.
Sodium-filled valves can be collected and sent for neutralizing to the Garantieprifstelle Werk StuttgartUntertirkheim.
Checking and machining 8
—— — nt. /e
1 Clean valves and check visually.
Valves with a burnt valve disk, with insufficient 72-3642 height ,,h’’ of the valve disk and valves with worn out or scored valve stem should be replaced.
2 Measure runout on valve stem. If runout exceeds 0.03 mm, replace valve.
3 Machine valve seat and face of valve stem.
Observe operating instructions of machine tool and adjusting angle.
4 Measure runout on valve seat and height ,,h’’ of the valve disk.
If the limit values are reached, renew valve.
5 Machine valve seats (05-291).
Note: Observe checking valve springs and valve spring preload (05–260).

