WIS 15-510

WIS 15-510

Removal

WIS 15-510 – rysunek

1 Remove protective cap, distributor cover, cable plug connections and vacuum lines.

WIS 15-510 – rysunek

2 Set engine to ignition TDC of 1st cylinder. For this purpose, the markings on distributor rotor and on distributor housing should be in alignment.

In addition, the pointer on crankcase should be above TDC mark of vibration damper.

1 TDC mark

WIS 15-510 – rysunek

Rotate engine with combination tool.

Attention! Do not rotate engine on fastening screws of camshaft sprocket. Do not rotate engine in reverse.

3 Loosen hex. socket screw of distributor attachment and remove ignition distributor.

R 100/6498

Installation

4 For installation proceed vice versa. Pay special attention to marks (refer to item 2).

5 Check dwell angle and firing point and adjust at normal coil ignition (15—500).