Testing normal coil ignition

WIS 15-515

Test values

Battery rest potentialapprox. 12 V
Starting voltageapprox. 10 V
Ignition coil voltage, terminal 15 (contact breaker closed)min. in. 5.0 5.0 V
Pre-resistance bridgemin. 9.6 V

Ignition coil (red sticker — primary) 1.2-—1.6Q

(red fastening clamp) at + 20 °C184052
(golden fastening clamp)144050

Conventional testers

Testing normal coil ignition – rysunek

Voltmeter, ohmmeter

Testing normal coil ignition – rysunek
Testing normal coil ignition – rysunek

Irt/ws

Wiring diagram: normal coil ignition

1 Ignition distributor 4 Pre-resistance Line colors:

2 Spark plugs 5 Ignition starter switch sw = black 3. Ignition coil 6 Starter rt =red

15,.3-515/1 F2

Checking voltages on battery

Rest potential

Pull high-voltage ignition cable 4 out of distributor cover and connect to ground. Operate starter while reading voltage.

Nominal value: approx. 12 volts

Starting voltage

Pull high-voltage ignition cable 4 from distributor cover and connect to ground. Operate starter while reading voltage.

Nominal value: approx. 10 volts

Testing voltages on terminal 15 of ignition coil

Switch on ignition. Pull high-voltage ignition cable 4 from distributor cover and connect to ground.

Connect plus cable of voltmeter to terminal 15 of ignition coil. Close breaker contact points and read voltage.

Nominal value: min. 5.0 volts

Pre-resistance bridge

Operate starter and read voltage

Nominal value: min. 9.6 volts