Testing cooling system pressure cap

WIS 20-4300

Testing cooling system pressure cap – rysunek
Testing cooling system pressure cap – rysunek

Operation no. of operation texts and work units or standard texts and flat rates:

P20.40-0220–57

Pressure cap with detent

Cap () tum anti-clockwise as far as detent 1 to release pressure.

ZN Do not open cap (5) unles: s coolant temperature is below 90 °C. Risk of scalding! Test cap (3) 124589009100 …………. attach to tester (2) 124 589 24 21 00, take off. Double connection (4) 124 589 53 63 00 attach to tester (2) 124 589 24 21 00, take off. Cap (5) attach to double connection (4), take off.

whi RA 20.1234-4300/1

Opening pressure of pressure relief valve test. See table for opening pressure. Vacuum valve test. Raise vacuurn valve (6) for this step.

Note The vacuum valve (4) must be resting against the rubber seal (5) of the sealing plate, it must be possible to raise it easily and it must spring back when released. The base for the sealing plate on the expansion tank must be flat. Replace pressure cap if corroded. The part no. and the pressure cap code number are stamped in the cap.

2-stage pressure cap In model 210

Gap (a) tum half a revolution anti-clockwise to release pressure.

aN Do not open cap (Sa) unless coolant temperature is below 90 °C. Risk of scalding! Adapter (3a) 210 589 03 68 00 attach to tester (2) 124 589 24 21 00, take off. 2-stage cap (5a) ….. scene eee eee screw onto adapter (3a), unscrew; pay attention to note. Opening pressure of pressure relief valve test; see table for opening pressure.

Note The cap code numbers are stamped in the cap. See note for dasign of 2-stage cap.

oti §=RA 20.1234-4300/2

Testing cooling system pressure cap – rysunek

Test data of cap with detent

Testing cooling system pressure cap – rysunek

Test data of 2-stage cap

Testing cooling system pressure cap – rysunek
Testing cooling system pressure cap – rysunek

Special tools

oti RA 20.1234-4300/3

Testing cooling system pressure cap – rysunek

Note A 2-stage cap is installed in model 210.

A The 2-stage cap must be screwed in far . enough until the lug engages in the notch on the coolant expansion raservoir. The cap has an additional pressure stage so that the system pressure is able to rise by up to 2 bar in the engine off heating phase without the coolant flowing out.

ahi §=RA 20.1234-4300/4