Function of electrical coolant level indicator

WIS 20-4450

Model 124

Function of electrical coolant level indicator – rysunek

1 Expansion reservoir Atel Coolant level waming lamp

51 Float a Microprocessor (base plate)

52 O-ring F Fuse and relay box

55 Circlip S41 Coolant level sensor Al Instrument panel unit WwW Ground

othe §=RA 20.1234-4450/1

General Operation The coolant level indicator monitors the coolant If the coolant is at the correct level, a permanent level in the expansion reservoir (1) when the magnet (2) in the fioat (61) and a permanent engine is running. magnet (3) in the sensor (S41) keep a contact When the ignition is switched on, the warning light (arrow) open. {Ale11) comes on weakly (check function) and If the coolant level is too low, the float (61) moves gees out if the coolant is at the correct level as down and the permanent magnet (3) closes the soon as the engine is started. contact (arrow) in the coolant level sensor (S41). The coolant level sensor (S41) has two retaining A permanent input signal (vehicle ground) exists lugs of different width and can only be installed in at the microprocessor (a) in the electrical base one position. It is sealed by means of an O-ring plate of the instrument panel unit (A1) and the (52) and is fixed in place by a circlip (55). warning lamp (A1e11) comes on with a bright light.

Models 129, 140, 202, 210

Function of electrical coolant level indicator – rysunek

Shown on model 129 F Fuse and relay box S41 Coolant level sensor

1 Expansion reservoir we Ground at front right (at headlight unit)

51 Float X24 Headlight wiring harness connector

54 Ring magnet (permanent magnet) AI Instrument panel unit Atet1 Coolant level waming lamp a Microprocessor (base plate)

ghhe = RA 20.1234-4450/2

General

In models 129, 140, 202, 210, coolant does not flow directly around the coolant level sensor $41) and the sensor can be removed and installed without draining the coolant in the expansion reservoir (1).

Operation

Function of electrical coolant level indicator – rysunek

If the coolant level is too low, the ring magnet (64) in the float (1) closes the contact (arrow) in the coolant level sensor (S41). A permanent input signal (vehicle ground) exists at microprocessor (a) in the electrical base plate of the instrument panel unit (A1) and the warning light (A1811) comes on with a bright light.

vommercially available tool

thie §=RA 20.1234-4450/3