Adjusting basic setting of hydraulic compensating elements

WIS 05-2140

Adjusting basic setting of hydraulic compensating elements – rysunek

Preceding work: Basic position of hydraulic compensating elements checked (05-2130). Camshaft bearing caps removed (05~2190).

51

P05 – 5243 – 37

Compensating element (58) together with the washer (57) 2… 2… 2. eee ee ee eee press out of rocker arm (51) with a aluminium or brass drift. Corresponding washer (57) with size (s) ……. match to checked size of residual stroke (z), specification 0.5 – 2.4 mm Matched washer (57) with compensating element (58) 2.6… 2 ee ee eee insert into rocker arm (51) until it touches snap ring (56)

Installation note

The grooves (arrows) of the washer (57) must face the compensating element (58). Fill chamber (a) of compensating element (58) with engine oil before installing.

mie =RA 05.1123-2140/1

If the residual stroke (z) cannot be reduced with the existing washers (57), adjust residual stroke (z) additionally withthicker ball socket (55). Rocker arm bearing bracket install (05-2320). Engine 2… ec ee crank with starter. Basic setting of hydraulic compensating elementS 0.0.0 eee eee check (05-2130).

Data, washer and ball socket

Washer (57) Ball socket (55)

Size „s” Part no. Size „c” Part no. mm

1.5 103 055 07 76 3.0 103 055 00 24

1.8 103 055 06 76 3.5 103 055 02 24

2.2 103 055 09 76

euinge §=RA 05.1123-2140/2