Testing oil level sensor

WIS 18-3320

Testing oil level sensor – rysunek
Testing oil level sensor – rysunek

$43

6 = P18 – 5116 – 55

Al instrument panel $2 Ignition starter switch a Microprocessor (base plate) $43 Oil level sensor et2 Oil level indicator lamp X27 Plug connection, starter harness FA Fuse and relay box

When dealing with the following complaints:

A: When key in position 2”, indicator lamp (e12) ……… does not light up.

B: When engine oil at „max.” level and engine running, indicator lamp (12) 2.2… ee eee shows a steady light.

C: When engine oil at „max.” level and engine running, indicator lamp (€12) 2… ee ee eee lights up intermittently.

wai =RA 18.1133-3320/1

Test data

Resistance of oil level sensor at „max.” oil level< 0.10 2
Resistance of oil level sensor at ”min.” oil level> 20 kQ

Test condition

Engine oil temperature> 60°C
Battery voltage12V

Special tool

Testing oil level sensor – rysunek

\ 201588009900

Commercially available tools and testers

Designation eg. Make, Order no.

Multimeter eg. Sun DMM-5

Test when dealing with complaint ”A”

Indicator lamp (e12) does not light up when key in position ”2” (requirement: voltage supply to instrument panel exists).

Bulb in order?

Yes No

Vv

Replace bulb

VV Replace base plate of instrument panel

End of test

aime §=RA 18.1133-3320/2

Test when dealing with complaint ”B”

Testing oil level sensor – rysunek

When engine oil at „max.” level and engine running, indicator lamp (e12) shows a steady light.

Test oil level sensorOS
Unplug connector from oil level sensor (S43). With multimeter, test pin of plug connection to ground.of pug eonnecton to
Readout: < 0.10 2
YesNo
Replace oil level sensor (18-3300).
Vv

Plug in connector of oil level sensor, test cable with oil level sensor to plug connection (X27). To do this, unplug connector of plug connection (X27) and test pin 3 of plug connection to ground with multimeter.

Readout: < 0.10 27
YesNo7

Vv

Open circuit in starter wiring harness.

v

Replace base plate of instrument panel or open circuit in wiring harness to base plate.

smite RA 18 1133-3320/3

Test when dealing with complaint ”C”

Indicator lamp (e12) lights up intermittently when engine running and oil at correct level.

Test switching lag of base plate in instrument panel. Run engine, unplug connector of oil level sensor.
Readout: indicator lamp (e12) lights up after a time of < 60 seconds.9 (e12) lights up after a
YesNo
Vv
Replace base plate of instrument panel (54-265).
Test oil level sensor and wiring harness, see test B.

End of test

euige §=RA 18.1133-3320/4