Removing and installing oil level sensor

WIS 18-3300

Preceding work: Operation no. of operation texts and work units or standard texts Bottom engine compartment panel removed (Maintenance and flat rates Manual Volume 2, Op. no. 6190). 18-4111, 18-4113

Engines except 4MATIC:

Removing and installing oil level sensor – rysunek

560

P18 ~ 0132–55

Engine of) 2.2… eee partially drain (about 2.5 liters), pour in (18-0020) Connector at oil level sensor (559) ……….. unplug, plug in Oil level sensor (559) 6.2… ee ee ee eee remove, install O-ring (558) 2.2. eee ee ee replace Engine 2.2… ce ee ee run and check for leaks

Note For operation of oi! level gauge see (18-3050)

wm =RA 18.1133-3300/1

Notes

Modified seal between oil level sensor and

oil sump The seal between oil level sensor and oil sump has been improved by modifying the material of the O-ring. The diameter is now 3.15 mm (was 3 mm). Identification: color green (was black)

Production breakpoint: 09/1986

Improved seal between oil level sensor and

oil sump

An improved seal between oil level sensor and oil sump has been achieved by altering the size of the O-ring.

Production breakpoint: 06/1987

SizePrevious versionPresent version
d,40.20 mm37.20 mm
oy
PO1-0187–13

aime RA 18.1133-3300/2

4MATIC engine

Removing and installing oil level sensor – rysunek
Removing and installing oil level sensor – rysunek
Removing and installing oil level sensor – rysunek

P18-5326–37

Engine of} 2.2… eee ee ee ee ee ee eee drain, collect, pour in (18-0020) Bottom part of oil sump (2) remove, replace gasket (4), install (10 Nm) Connector (11) and locking element (12) …… unplug, plug in Bolts (13) and (6) …………-….-20005 unscrew, screw on (10 Nm) Supporting bracket (5) ……….—.-.05. take off, fit on Oil level sensor (10) ……..-……00006unbolt, bolt on O-ring (8) at connector (7) ………–..006replace

wie §=RA 18.1133-3300/3