Removal and installation of engine longitudinal regulating shaft

WIS 30-310

Note When removing transmission, remove longitudinal regulating shaft, so that bearing on front wall is not damaged by tilting of engine.

Removal and installation of engine longitudinal regulating shaft – rysunek

A. Model 116.120

Removal

1 Disconnect regulating rods.

Removal and installation of engine longitudinal regulating shaft – rysunek

2 Turn longitudinal regulating shaft to the left until groove disengages from clip. Push longitudinal regulating shaft to the rear and remove.

Installation

4 For installation proceed vice versa. Grease bearing points as well as ball sockets of regulation with Molykote Longterm 2.

5 Adjust throttle linkage (30—300).

Removal and installation of engine longitudinal regulating shaft – rysunek

B. Mode! 123.1

Removal

1 Remove regulating rod (5) and lock (33).

Removal and installation of engine longitudinal regulating shaft – rysunek

2. Slide longitudinal regulating shaft in forward direction out of bearing on front wall. Then remove toward the rear.

Installation

3 For installation proceed vice versa. Grease bearing points as well as ball sockets of regulation with Molykote Longterm 2.

4 Adjust throttle linkage (30-300).

C. Model 126.120

Removal and installation of engine longitudinal regulating shaft – rysunek

Removal

1 Disconnect regulating rods (5 and 61).

2 Remove lock (84), corrugated washer (83) and plastic spacing ring (32).

Removal and installation of engine longitudinal regulating shaft – rysunek

3 Push longitudinal regulating shaft (3) to the rear and remove.

Installation

4 For installation proceed vice versa. Grease bearing Points as well as bal! sockets of regulation with Molykote Longterm 2.

5 Adjust throttle linkage (30~300).