Adjusting start and stop cable control (engine 615, 616 with M-injection pump)

WIS 30-340

Adjusting start and stop cable control (engine 615, 616 with M-injection pump) – rysunek

Adjustment

1 Set ignition lock to zero position so that engine is not starting.

2 Set preglow starting switch into driving position.

3 Remove washer (5) by pulling out cotter pin.

1 Adjusting lever 4 Wirecoil 2 Oblong eye 5 Washer 3 Fastening screw

Adjusting start and stop cable control (engine 615, 616 with M-injection pump) – rysunek

4 Loosen fastening screw (3) and adjust wire coil (4) with oblong eye (2) in such a manner that at least 2 mm play is available between center of axis and oblong eye (distance ‘’a’’).

5 Pull preglow starting switch to start and check whether the adjusting lever (1) rests against start position stop when in starting position.

6 Run engine up to operating temperature. Turn idle speed adjuster completely counterclockwise and stop engine.

If engine is not stopping correctly, slide wire coil (4) slightly in direction of stop.