Checking cylinders for leakage

WIS 00-120

Data

pressure lossmax. 25 %
and cylinder head gasketmax. 10 %
and piston ringsmax. 20 %

Special tool

Socket 27 mm Lf to crank engine woce6189 – 001 589 65 09 00

Commercially available tool

e.g. Bosch, EFAW 210A Cylinder leakage tester SUN, CLT 228

Checking

1 Warm up engine to operating temperature.

2 Unscrew glow plugs.

3 On engine models 615 and 616 featuring injection pumps with pneumatic governors, detach rubber gaiter at throttle body and set throttle valve to full delivery.

On engines featuring injection pumps with mechanical governors, detach air filter.

4 Remove oil filler cap.

5 Remove radiator cap and top up coolant.

6 Screw connector into glow plug hole of No. 1 cylinder.

7 Set piston of No. 1 cylinder to ignition TDC.

Checking cylinders for leakage – rysunek

To do so, turn engine at crankshaft, using tool combination.

8 Connect cylinder leakage tester to air system. Calibrate tester.

9 Screw tester connecting hose to connector.

Make sure that crankshaft does not turn.

R 100/6498

Checking cylinders for leakage – rysunek

10 Note pressure loss on tester.

11 Listen to check whether pressure escapes through intake pipe, exhaust, oil filler cap, glow plug hole of adjacent cylinder or radiator cap.

12 Check all cylinders in firing order.

Note: The reading will be falsified if the piston ring gaps of a particular piston are directly above one another.

Checking cylinders for leakage – rysunek

In case of doubt, continue to run engine and then check cylinders for leakage again after some time has elapsed.

Checking cylinders for leakage – rysunek

Engines 615, 616

Engine 617