Checking compression pressure
WIS 00-115
Testing data in bar positive (atii) for hot engine
Compression pressure normal 22–24
ca. 15 Minimum compression pressure
Permissible difference between any two cylinders max. 3
Nm (kpm) Tightening torques
25 (2.5) Cap nuts of injection lines
Injection nozzles in precombustion chambers
Special tools
RAWAL we Qr— X ey Get xX Compression pressure recorder with accessories i – 001 589 47 21 00
sidiie sale
Remote starter switch (individual component of compression pressure recorder 001 589 46 21 00) – 001 589 46 21 08
Note Check compression pressure at 80 °C coolant temperature. The compression pressure can be checked through the spark plug hole or the precombustion chambers. If engine fails to reach minimum combustion pressure, check cylinders for leakage (OO—120).
Checking
1 Unscrew all glow plugs or injection nozzles.
2 Connect remote starter to terminals 30 and 50 on starter.
Positive battery terminal can be used in place of terminal 30.
3 With transmission in neutral, crank engine several times to eject carbon deposits.
Caution:
On engines featuring injection pumps with mechanical governors, first move stop lever (stop) in direction of engine so that injection pump will not inject fuel.
4 Screw connector into glow plug hole or precombustion chamber of each cylinder in turn.
5 Connect compression pressure recorder.
6 Tocheck pressure, crank engine by 8 revolutions while using full throttle.
Compression pressure recorder connected to glow plug hole.
On engine models 617 in general and on models 615, 616 featuring injection pumps with mechanical governors, do not use full throttle because these engines do not have throttle valves.
7 Prior to inserting the injection nozzles, fit new nozzle plates.
Compression pressure recorder connected to precombustion chamber




