Programmed repairs engine 605.911, 606.910 Combustion M/RSF

WIS misc-pr

Problem:

Ajter vehicle has stood for a lengthy time (e.g. over night) engine Applies to all models only starts after lengthy attempt, has poor throttle response and with retrofitted cuts out again immediately. immobilizer.

Cause

Remedy Part Part no. Quantity Replace non-return valve, aeeemrntnenmnnnenanaentnnetnmnennnntnnrernnretnnnennnnetanenennnemaneeantsenennnnetaneeanesaneae Non-return valve 000 476 37 32 1 (black anodized)

Hose clip 0039979090 4

Problern:

Programmed repairs engine 605.911, 606.910 Combustion M/RSF – rysunek

Engine surges after cold start Engine 606.910 up to 19.10.94

iSC control module with 007 545 96 32 software 10/94 and green dot identification or as of production date 41/94 – testing, setting automatic transmission idle speed (see 07.1-2053),rtrnrrrrerresreeerenenenrreneerenrern re 3° Install ISC control module with software ISC control module with 006 545 36 32 ‘ ae ° software 10/94 and green dot 10/94 and green dot identification or as of identification or as of production date 41/94. production date 41/94 – manual transmission

PR P1RBO7.99.1699 /1

Problem: Engine 605.911: manual transmission up Black exhaust on long motorway trips in upper to engine end no.: engine speed range (> 4000 rpm) 038713 automatic transmission up to engine end no.: 015394

Engine 606.910: as of engine end no.: 000001

Cause Coo, Designation Part no. Incorrect Gipstick installed. emma nertnnnnnernntennnnnnneeennnnnaneneeneannnnntestuauneaterentntnonnteneerenmonereerevaenantenteetat Damage code: 01 112 88 Dipstick eng ine 605/ 602 010 14 72 Remedy identification 60214 Replace dipstick. Dipstick engine 606/ 606 010 04 72 identification 60604

Problem: Engine 605.911 in model 124.126, Engine cuts out when driving 124.186 up to 30.9.95

Programmed repairs engine 605.911, 606.910 Combustion M/RSF – rysunek

Engine 606.910 in model 124.131, 124.191 up to 30.9.95

Programmed repairs engine 605.911, 606.910 Combustion M/RSF – rysunek

Cause Bush at injection pump for attaching fuel pipe worn,

Install modified fuel pipe with banjo bolt. Tightening torque of banjo bolt for injection pump feed pipe 1241.2 Nm.

PR P1RB07.99. 1699 /2

Programmed repairs engine 605.911, 606.910 Combustion M/RSF – rysunek

P07.00–02:36–35

PR P1RB07.99.1699 /3