Testing and setting vacuum control valve
WIS 07.1-1826
Preceding work: Operation no. of operation texts and work units or standard texts and flat rates: 07-1826
Test conditions: Run engine up to normal operating temperature (approx. 80 °C coolant temperature). Accelerator control correctly set (30-300).
comings RA 07.1.1044-1826/1 connect vacuum tester (019) to damper (72) of vacuum line and read off vacuum at idling speed. Specification: Engine 602, 420 +25 mbar Engine 603, 385 + 25 mbar
When engine is switched off, move accelerator control to full-load stop. Specification: 0 mbar, it may be necessary to set vacuum control valve. Test vacuum lines, test vacuum pump, renew vacuum control valve. Setting vacuum control valve slacken fastening bolts (65c), run at full throttle until control lever of injection pump is resting against full-load stop. Turn vacuum control valve (65) in direction of arrow until a resistance is felt. Tighten vacuum control valve in this position. Vacuum control valve replace (27-140).
Special tool
cutis = RA 07.1.1044-1826/2
Engines 602.962, 603.960/963/971 Vacuum control valve modified, seal integrated.
Production breakpoint: as of November 1993 Model Engine Engine end no. Automatic transmission
124.128/188 602.962 019269
124.133/193 603.960 049904 124.333/393 603.963 004244 140.134 603.971 008156
Engines 602.962, 603.960/963/971 Vacuum control valve modified, restrictor integrated in vacuum control valve.
Production breakpoint: as of June 1994
Model Engine Engine end no. Engine end no. Manual transmission Automatic transmission
124.128/188 602.962 032105 020045
124.133/193 603.960 – 052278
124.333/393 603.963 : 004444
140.134 603.971 – 012107
wtie = =RA 07.1.1044-1826/3


