07.1 Testing, Adjusting Idling Speed

WIS 07.1-2053

07.1 Testing, Adjusting Idling Speed – rysunek

Preceding work: Operation no. of o tion texts and work units or standard texts and flat rates: 07–20 3 or 2056

Tester (001) and pulse generator (021) …….. connect, disconnect.

Note On model 140 the TDC sensor is installed on the body in the diagnostic socket (X11/4).

Accelerator control… 6. ee eee stew ween examine for ease of operation. Idle stop on Bowden cable …………5… . check, the spring plate (226) must be resting against the compression spring (227) free of tension.

Engine 20… 0… eee eee eee eee eee eee = Warm Up to Operating temperature (coolant temperature approx. 80 °C). 2-pin coupling at actuator (Y22) …………. unplug, plug in. Idling speed …… seem eee eee eee eee . check, adjust (see table). Slacken locking nut (3a) for this step. Engine running ………. cence enews eee check. Switch on all ancillaries for this step.

anhtiy RA 07.1.1051-2053/1

07.1 Testing, Adjusting Idling Speed – rysunek
07.1 Testing, Adjusting Idling Speed – rysunek

Adjusting idle s ed by means of resistance trimming plug Isa) Ca) only Model Years 1986, 1987 If complaints are received regarding idling speed, it is possible to vary the idling speed. The positions of the resistance trimming plug ara listed in the table opposite.

07.1 Testing, Adjusting Idling Speed – rysunek

ing Special tool

otitis RA 07.1.1064-2053/2

07.1 Testing, Adjusting Idling Speed – rysunek

Commercially available tools and testers

Sun, DIT 9000

07.1 Testing, Adjusting Idling Speed – rysunek

Adjusting

1 Connect digital tester (001) and pulse generator (021).

07.1 Testing, Adjusting Idling Speed – rysunek

2 f€xamine accelerator control for ease of movement and condition. Checking idle stop: For this step, the spring plate (226) of the Bowden cable (230) must be resting against the compression spring (227) free of tension.

Engine 602.96

egitim =RA 07.1.1064–2053/3

07.1 Testing, Adjusting Idling Speed – rysunek

Engine 603.96

3. Warm up engine to operating temperature (coolant temperature approx. 80 °C).

4 Unplug 2-pin coupling at actuator, plug in.

07.1 Testing, Adjusting Idling Speed – rysunek

5 Check idling speed, adjust by slackening locking nut (3a).

07.1 Testing, Adjusting Idling Speed – rysunek

Specifications:

6 Switch on all ancillaries and check smooth engine running.

otihips ~=RA 07.1.1064-2053/4