Checking valve guide
WIS 05-2845
Preceding work: Cylinder head rernoved. Valves removed.
Left cylinder head, engine 119.960
Inlet, exhaust valve guide (54) and (56) in longitudinal and transverse direction ……. check with gauging drift (4). Gauging drift 102 589 00 23 00 inlet valve guide dia. 8 mm. Gauging drift 117 589 03 23 00 exhaust valve guide dia. 9 mm. Gauging drift 102 589 01 23 00 inlet, exhaust valve guide dia. 7 mm. When performing this step, check whether the „no go” stud (5) with the wear limit (+220) can be inserted into the valve guides (54) and (56) over its entire length (5 mm). If the gauging drift (5) can be inserted over its entire length, replace valve guide (05-2850).
atime RA 05.1922-2845/1
Retaining groove (arrows) of valve stem seal on valve guides (54) and (56) ………..00check. ; If the retaining groove is worn (arrows) with result that the valve stem seal is no longer tightly seated, replace valve guide (05-2850).
Special tools
CN
Note Engine 119.96: as of engine end no. 011931 inlet and exhaust valve guides with ID 7 mm have been fitted. Engine 119.97: as of start of production inlet and exhaust valve guides with ID 7 mm have been fitted.
wibie RA 05.1322-2845/2




