Removing and installing oil level sensor
WIS 18-3300
Preceding work: Operation no. of operation texts and work units or standard texts Bottom engine compartment panel removed and flat rates: (Maintenance Manual 6190). 18-4111, 44119 Engine oil drained (18-0020).
Cable straps on bottom part of oil sump ……. detach, attach. Oil line of automatic transmission on bottom part of ofl sump (8) 6.6… ee eee sees unboalt, bolt on (9 Nrn). If level control fitted: high pressure flexible hose on bottom part of oil sump (8) ……65.. unbalt, bolt on (9 Nm). Bottorn part of oil surnp (8) see unbolt, bolt on (9 Nm). Sealing surfaces …… seen ee eee nee clean. Gasket (6) 2… ee ee eee eee replace. Plug connection of oil level sensor (S43) at CrankcaS@ 6. eee eee unplug.
athe RA 18.1322-3300/1
Locking element (3) at pin (2) of plug connection . pull off, fit on. Oil level sensor (S43) with connection cable (5) and pin (2) of plug connection ……….. vee remove, install. Model 140: spacer sleeves «1.1.2.2… 0006. do not forget, see Note. O-ring 5. eee see eee ee eee replace. Leaks ………65. dee eee eee wee sae check with engine running.
Special tool
Note Check length of spacer sleeves. Attach oil level sensor with 2 spacer sleeves, length 12 mrn, part no. 119 991 02 40 and 2 M6 x25 hexagon socket bolts, part no. 000 912 006 042, to oil pump. If spacer sleeves are too long (20 mm), oil warning lamp already lights up between Max. and Min. markings on dipstick. Standard production break point of 12 mm long spacer sleeves (was 20 mm): Engine no. 119.970 12 001 385 119.971 12 000 604
atin RA 18.1322-3300/2

