Electrical function of oil level indicator
WIS 18-3100
Model 129
1 Instrument cluster a Microprocessor
3 Ignition starter switch b Fuses § and 9
5 Plug connection, oil level sensor e Oil tevel indicator level (bottom right of crankcase) $43 Oil level sensor X27 Plug connection, starter wiring hamess
General
The electric oil level gauge monitors the engine oil level in the sump when the engine is running and the engine oil temperature is above 60 °C. When ignition is switched on, the indicator lamp lights up and goes out as soon as the engine is started.
atime RA 18.1323-3100/1
Function
The engine oil in the oil level sensor (S43) is matched to the engine oil level in the sump through the drain drilling (c). When the engine oil is at the correct level, the contact (arrow) is closed by the float (6) with a magnet (7) and a permanent input signal (vehicle ground) is supplied to the microprocessor {a) in the electrical base plate of the instrument panel unit (1).
If the engine oil level is too low, the float (6) moves down and opens the contact (arrow). The input signal is thus interrupted and the oil level indicator lamp (a) lights up after 60 sec. (switching lag controlled by microprocessor (a) in instrument panel unit). If the engine oil level is too low or if there is an open circuit in the wiring, the oil level indicator larnp (e) remains on after the engine is running. The drain drilling (c) is opened by the bimetal snap plate (a) from an engine oil temperature of 60 °C and the engine oil level in the oil level sensor is matched to that in the sump.
AN Engine oil change Below 60 °C the engine oil is viscous and only flows back slowly into the surnp; i. @. an oil level measured at a temperature below 60 °C does not correspond to the actual oil capacity. When changing the engine oil, the oil level sensor ($43) is filled through the vent passage (d) as the passage (c) is closed by the cold engine oil at approx. 30 °C.
athe RA, 18.1323-3100/2
B. Model 210
General
The electric oil level indicator monitors the engine oil level in the surnp when the engine is running and the engine oil temperature is above 60 °C.
Operation The engine oil in the oil level sensor ($43) is lf the engine oil level is too low or if there is an matched to the engine oil level in the sump open circuit in the wiring, the oil level indicator through the drained drilling (c). H the engine oil comes on with an additional warning signal is at the correct level, the contact (arrow) is about 25 seconds after the engine has started. The warning indicator remains on for a further closed by the float (6) with a magnet (7) and a permanent input signal (vehicle earth) is sup2 minutes or so after the engine is switched off. plied to the ME-SFI control module. The warning signal can be canceled when If the engine oil level is too low, the float (6) driving by pressing the R button. moves down and opens the contact (arrow). This causes the input signal to be interrupted and the engine oil level indicator in the instrument cluster comes on after 60 seconds (operating time lag) and, in additon, a warning signal sounds.
atime RA 18.1323-3100/3
Engine oil change The drain drilling (c) is opened by the bi-rmetal snap plate (8) from an engine oil temperature of 60 °C and the oil level in the oil level sensor is adjusted to that in the sump. At temperatures below 60 °C, the engine oil is viscous and flows back only slowly into the sump, i.e. a capacity measured at temperatures below 60 °C does not correspond to the actual oil capacity. When the engine oil is changed, the oil level sensor ($43) is filled through the vent drilling (d) as the drilling (c) is closed at about 30 °C as a result of the cold engine oil.
wtb RA 18.1923-3100/4




