Electrical function of coolant level indicator

WIS 20-4400

sunauaateneeneednustnsusnedensesnsneneesnsensnesenananenqenenvacunsestsneensuasuenseenaennsenseennsennsunnerenucnnsuaseenaeyaseneqendauensunsenastunnevenensennnsunnesssunaasenqvensecasuanauedsuaneneusnuntsansnnnnnnensaneneeennsenQeunsensd

A. Model 124

Electrical function of coolant level indicator – rysunek

1 Expansion reservoir Aje11 Coolant level indicator lamp

51 Float a Base plate

52 O-ring F Fuse and relay box

55 Circlip $41 Coolant level sensor At Instrument panel unit Ww Ground

awit RA 20.1322-4400/1

General Function The coolant level indicator rnonitors the coolant If the coolant is at the correct level a permanent level in the expansion reservoir (1) when the magnet (2) in the float (61) and a permanent engine is running. magnet (3) in the sensor (S41) hold a contact When the ignition is switched on, the indicator (arrow) open. lamp (Ate11) lights up weakly (check function) If the coolant level is too low the float (61) moves and goes out as soon as the engine is started down and the permanent magnet (3) closes the provided the coolant is at correct level. contact (arrow) in the coolant level sensor (S41). The coolant level sensor ($41) has two retaining A permanent input signal {vehicle ground) exists lugs of different width and can be installed only in at the base plate (a) of the instrument panel unit one position. It is sealed by means of an O-ring (A1) and the indicator lamp (Aie11) lights up 52) and fixed in position by a circlip (55). brightly.

B. Models 129, 140

Electrical function of coolant level indicator – rysunek

F Fuse relay box

1 Expansion reservoir $41 Coolant level sensor

51 Float Ww2 Ground, front right (at headlarnp unit)

54 Ring magnet (permanent magnet) Al Instrument panel unit X24 Plug connection headlamp wiring harness Atel Coolant level indicator lamp a Base plate

aime RA 20,1922-4400/2

General The coolant level sensor (S41) is not directly enveloped in coolant and can be removed and installed without draining the coolant in the expansion reservoir (1).

Function lf the coolant level is too low the ring magnet 54) in the float (1) closes the contact (arrow) in the coolant level sensor (541). The permanent input signal (vehicle ground} exists at the base plate (a) of the instrurnent panel unit (A1) and the indicator lamp (A1e11) lights up brightly.

win RA 20.1322-~4400/3