Preceding work: Operation no. of operation texts and work units or standard texts

WIS 03-3240

Preceding work: Operation no. of operation texts and work units or standard texts – rysunek
Preceding work: Operation no. of operation texts and work units or standard texts – rysunek
Preceding work: Operation no. of operation texts and work units or standard texts – rysunek

Operation no. of operation texts and work units or standard texts Preceding work: and flat rates Belt pulley, vibration damper and hub removed (03-3420). 03-3000 – 01-3112

Belt pulley (12), vibration damper (13) and hub (14) remove, install (03-3420). Radial seal (16) remove (step 2). Mounting bore clean, deburr. Sealing lip of radial seal (16) oil (step 4). Radial seal (16) install with insertion sleeve, special tool 119 589 01 14 00 (step 5).

A Pay attention to installation position in the case of hubs (14) with running marks (step 6). Leaks check with engine running.

ath RA 03.1321-3240/1

Preceding work: Operation no. of operation texts and work units or standard texts – rysunek

Note

Preceding work: Operation no. of operation texts and work units or standard texts – rysunek

An oil leak can be determined after spraying the dried and cleaned surrounding area with Mercedes-Benz white contrast spray 000 989 03 59.

1 Check hub of belt pulley for running marks.

If running marks are present, install radial seal ; woe rn offset 3 mm to the inside (see step 6).

wth §=RA 03.1921-3240/2

Preceding work: Operation no. of operation texts and work units or standard texts – rysunek

2 Lever out radial seal with a screwdriver.

AN, Do not darnage crankshaft and rnounting bore for the radial seal, use clean cloths as a base.

3 Deburr edge of mounting hole for the radial seal.

4 Oil sealing lip of the radial seal.

Preceding work: Operation no. of operation texts and work units or standard texts – rysunek

A Do not use grease. Grease prevents the angled webs on the sealing lip transporting back the engine oil.

Preceding work: Operation no. of operation texts and work units or standard texts – rysunek

5 Fit radial seal (16) onto the side a of the insertion sleeve 119 589 01 14 00 and draw in as far as the stop with bolt (11) and 4 Belleville spring washers (11a).

as The radial seal (16) must be at right angles to the hub otherwise it will not provide a proper seal.

6 If the hub has running scores, position radial seal (16) 3 mm offset to the inside. To do this, fit radial seal (16) onto the side b of the insertion sleeve 119 589 01 14 00 and draw in as far as the stop.

A= Standard position of radial seal 8 = Repair position of radial seal

atime RA 03.1321-3240/3

7 Install belt pulley, vibration damper and hub (03-3420).

8 Run engine and check for leaks.

wtb RA 03.1321-3240/4