Decoking valves

WIS 05-293

Equipment

Sandblasting device for walnut shell granulatee.g. Alfred Karcher Leutenbacher StraRe 30–40, D—7057 Winnenden Order No. 1.486.601
Walnut shell granulate (25 kg) Grain size 1–1.5 mme.g. Eisenwerk Wirth GmbH & Co. Friedrichshaller StraRe, D-—-7107 Bad Friedrichshall Order No. 10407

Note

Decoking valves – rysunek

Transition fault during the warming-up phase on vehicles with KA injection system can be caused by coked-up inlet valves.

The inlet valves can be cleaned with a sandblasting device without removing the intake manifold.

Sandblasting device CWOMANOAMNAW NHN Power connection cable (220 volts) Compressed-air connection Blow-out valve Compressed-air supply line Granulate feed line Compressed-air gun with nozzle Adapter Extraction line with plug connection = Extraction pipe

Cleaning procedure

Wainut shel! granulate under high pressure is blasted on the disks of the closed inlet valves via the mounting bores of the injection valves. At the same time, the carbon residue is extracted together with the granulate via the throttle valve pipe into the sandblasting unit.

The valve disk is partly obstructed by the valve stem. In order to clean the obstructed part the valve must be turned once by 180°.

Maintenance and filling of sandblasting device

Decoking valves – rysunek

1 After approx. 20-30 cleaning processes, shake off the carbon pieces on the outside of filter bag (arrow).

2 When fitting the upper part, observe the marking (M).

Decoking valves – rysunek

3 Fill the unit lower part with approx. 4 kg of walnut shell granulate, grain size 1—1.5 mm up to the lower edge (arrow).

4 |f lumps are formed and in the case of high dust content the granulate must be renewed because of its inefficient cleaning effect.

Decoking

1 Remove mixture control unit with air intake housing.

2 Remove injection valves.

3 Remove all rocker arms and thrust pieces.

Caution! Rocker arms and thrust pieces must be installed in the same position from which they were removed.

Decoking valves – rysunek
Decoking valves – rysunek

5 Fit adapter (8) with open throttle valve.

6 Connect extraction line (9) to the adapter (8).

Decoking valves – rysunek

7 Place compressed-air gun (7) with nozzle in the bore for the injection valve. Blast the injection valve for approx. 30—60 seconds.

Decoking valves – rysunek

8 Blow out intake port with the blow-out valve (4) via the injection valve bore with the extraction switched on.

9 Force inlet valve down by means of the valve spring compressor 123 589 03 61 00 while turning the valve by 180°.

10 Blast inlet valve for approx. 15—30 seconds.

Decoking valves – rysunek

11. Blow inlet port with blow-out valve (4) via the injection valve bore with the extraction switched on.

Decoking valves – rysunek

12 Insert the extraction pipe (10) via the throttle valve intake pipe and extract the remaining granulate from the intake manifold lower part and from the exhaust gas recirculation line.

13 Using a light, inspect intake manifold lower part and all cylinders for residual granulate, extract if necessary.

14 Flush throttle valve intake pipe and throttle valve with benzine.

15 Install removed parts.

16 Adjust idle speed (07.3—100).