Replacing core hole closing cover in cylinder crankcase

WIS 01-140

Special tool

Mandrel for knocking in the _ 102 589 00 15.00 core-hole closing covers se

Note

Replacing core hole closing cover in cylinder crankcase – rysunek

Starting with chassis end numbers named below the core holes in cylinder crankcase are closed with sheet metal covers (34 mm dia.}. The closing plugs (M 30 x 1.5) are generally no longer required. Leaking closing covers must be replaced on principal.

Replacing core hole closing cover in cylinder crankcase – rysunek

Driving direction left 103 -14508

Model Chassis end no.

115.015 315 555 115.017 087 250 123.020 011 837 123.023 019 180 123.043 Start of series 123.083 Start of series

Transmission side 103–14 507

Replacing core hole closing cover in cylinder crankcase – rysunek

At the right (driving direction) the closing plug (M 38 x 1.5) remains in place.

This core hole can be used to insert cooling water preheater.

Driving direction right 103–14 506

Replacement

Replacing core hole closing cover in cylinder crankcase – rysunek

1 Completely drain coolant.

2 Remove components which obstruct axis (e.g. transmission, intermediate flange, exhaust manifold etc).

Drain plug on crankcase

Replacing core hole closing cover in cylinder crankcase – rysunek

3 Position a chisel with narrow blade or a screw driver into deep drawn edge of closing cover.

Replacing core hole closing cover in cylinder crankcase – rysunek

4 Carefully knock closing cover on one side down until cover has turned around its own longitudinal axis (approx. 90°).

Replacing core hole closing cover in cylinder crankcase – rysunek

5 Position water pump pliers against flange of projecting section and pull out closing cover.

Replacing core hole closing cover in cylinder crankcase – rysunek

7 Coat core hole with Sealing glue 002 989 947],

8 Lock-jn new Closing COver with self-made Mandre},

Replacing core hole closing cover in cylinder crankcase – rysunek

9 Attach removed components.

10 Aad coofant,

Note: The se aling glue should before addin Cure for approx, 45 min,

9 Coolant,

11 Run engine warm and check fo; leaks.

91.3~149/3 F2