Renewing front crankshaft radial sealing ring

WIS 03-324

Tightening torques Nm

Bolt M 18 x 1.5 x 45 to crankshaft 270–330

Bolts M 8 x 20 35

Special tools

Renewing front crankshaft radial sealing ring – rysunek

Torque wrench 3/4” square, 150-500 Nm – 001 589 31 21 00

Puller for balancing disc – 116 589 10 33 00

Detent – 110 589 00 40 00

Socket 27 mm, 1/2″ square \ “6 – 001 589 65 09 00

Puller for spacing ring – 102 589 00 33 00

Installer for radial sealing ring od – 130 589 00 61 00

Conventional tool

Adapter 3/4’ square socket e.g. made by Hazet, D—5630 Remscheid to 1/2‘ square head order no. 1058 R-1

Note

Renewing front crankshaft radial sealing ring – rysunek

On these engines, there are oil pans with and without machined face on mounting bore for radial sealing ring (arrow).

On oil pans with unmachined face, only radial sealing rings with half shoulder and on oil pans with machined face rings with half and all-around shoulder may be installed.

Oil pan with machined face

Renewing front crankshaft radial sealing ring – rysunek
Renewing front crankshaft radial sealing ring – rysunek

Oil pan with unmachined face

A Radial sealing ring with half shoulder B Radial sealing ring with all-around shoulder

Removal

Renewing front crankshaft radial sealing ring – rysunek

19c15 16 17 18 25 26 28 27 30

1 Remove cooler and fan.

2 Remove pulley (19c) and balancing disc (24) (03-340).

15 BoltM 18x 1.5 x 45 24 Balancing disc

16 Plate springs 25 Radial sealing ring 17. BoltsM8 x 20 26 Spacing ring

18 Washer 27 Woodruff key 18a Thrust washer 28 Crankshaft gear 19c Pulley 30 Crankshaft

23 Set pin8x8

Detail X 24 18a 23

3 Force out radial sealing ring by means of a screwdriver, making sure that the crankshaft journal and the mounting bore are not damaged.

Renewing front crankshaft radial sealing ring – rysunek

4 Remove spacing ring with puller, if noticeably worn.

Installation

5 Deburr mounting bore for radial sealing ring and clean.

Note: Do not coat mounting bore and radial sealing ring with sealing compound.

6 Install new spacing ring.

Renewing front crankshaft radial sealing ring – rysunek

7 Moisten new radial sealing ring with oil at sealing lip and in the dust-sealing lip area and mount with installer.

Attention! The radial sealing ring should be accurately square in relation to crankshaft journal, since otherwise no perfect sealing will be obtained.

8 Install balancing disc und pulley (0O3—340).

9 Install fan and cooler.