Checking idle speed stabilization with rpm increase following start

WIS 07.3-150

Conventional tools

Revolution counter

Digital tester e.g. made by Bosch, MOT 001.3

Testing

Checking idle speed stabilization with rpm increase following start – rysunek

1 Run engine at idle.

2 Pull off gray/black vacuum line (arrow) on 3 or 4-point rubber distributor (to reduce vacuum), put back again after approx. 3 seconds; idle speed should increase by approx. 500/min for a short period.

Checking idle speed stabilization with rpm increase following start – rysunek

Note: On model 123 and 126, owing to better access, the upper vacuum line can be pulled from switchover valve (43a). As a result, the decel circulating air valve (11) is provided with atmospheric air via 3 or 4-point rubber distributor (refer to function diagram).

Checking idle speed stabilization with rpm increase following start – rysunek

If there is no rpm increase, check line for passage. Renew decel circulating air valve (11), if required.

Checking idle speed stabilization with rpm increase following start – rysunek
Checking idle speed stabilization with rpm increase following start – rysunek

1 Mixture controller a Connection switchover valve Color code

10 Idle speed air screw decel shutoff gr =gray

11 Decel circulating air valve b Connection switchover valve ws = white

12 Intake manifold rpm increase air conditioning

96 Auxiliary air valve c To idle speed air duct in intake manifold

Note: For operation decel shutoff and idle speed stabilization refer to 07.3–500.