Repairing and squaring connecting rods

WIS 03-313

Data

Center of conrod bearing bore to 131.950 center of conrod bushing bore 130.050

Width of conrod at conrod bearing bore 27.890 and conrod bushing bore 27.857

Basic bore for conrod bearing shells 51.619 51.600

26.021 Basic bore for conrod bushing 26.000.

Conrod bushing inside dia.23.013 23.007
Peak to valley height on inside of conrod bushing0.004
Permissible stagger of conrod bore to conrod bushing bore in reference to a length of 100 mm01
Permissible difference in parallel! between axes: conrod bearing bore to conrod bushing bore in reference to a length of 100 mmdia. 0.015
Permissible deviation of conrod bearing bore from true0.020
Permissible difference in weight of all connecting rods of one engine5 gr.
Tightening torque Conrod nutsInitial torque Torque angle40–50 Nm 90–100°

Conventional tool

Made by Krupp GmbH, 5309 Meckenheim Connecting rod checking and straightening tool e.g. Model CL 6

Note

Repairing and squaring connecting rods – rysunek

Connecting rods, which are overheated (blue discoloration) due to bearing damage, may not be re-used.

The connecting rod and its cap are marked to fit together. The connecting rod stem must not show cross scoring and notches.

Connecting rods with a machined conrod bushing are delivered as replacement parts.

Repairing and squaring connecting rods – rysunek

When renewing conrods pay attention to different weights of rods.

Repairing

1 Check conrod bolts and replace if necessary (03-310).

2 Check conrod bolt bores.

Repairing and squaring connecting rods – rysunek

Place conrod cap on aconrod bolt. If the conrod cap moves down by its own weight, the connecting rod must be replaced.

Repairing and squaring connecting rods – rysunek

3 Mount connecting rod bearing cap and tighten to 40—50 Nm and 90—100° angle of rotation torque.

4 Measure conrod bearing basic bore. If a basic bore exceeds the value of 51.62 mm or shows conicity, hone bearing surface of bearing cap on a surface plate up to max. 0.02 mm.

Repairing and squaring connecting rods – rysunek

5 Press in new conrod bushing that oil bores match.

Installation pressure 2500 Nm.

6 Mill or ream out conrod bushing.

7 Hone side bearing surfaces of connecting rod on a surface plate.

Squaring

8 Square connecting rod with a conrod tester.

Repairing and squaring connecting rods – rysunek

9 Align parallel of conrod bore to conrod bushing bore.

Repairing and squaring connecting rods – rysunek

10 Correct stagger of conrod bore to conrod bushing bore.