Testing cylinders for leaks
WIS 01-0150
Warning instructions when hood open (01-0035). Operation no. of operation texts and work units or standard texts ir oles 1 4+ ANSOFY and flat rates: Air cleaner removed (ARO9.10-1050D) 01-1300
Engine …. Sete tee ete nee tee ete tees warm up to normal operating temperature. ‘Ground cable at battery 0.00 eee disconnect, connect, encode radio, model 140 normalize power windows. Spark plugs ……….020005 cote eww e ee remove, install (AP15.00-1580CA). Cap (1) on expansion reservoir (2) ……….. open, leave open, close. Coolant leval eee ee ee ee adjust to correct level (20-0100). Oil fillercap @) see ene eee . take off, fit on. Cylinder leak tester (5)… eee eee eee connect to compressed air system. Tester (5)… sence eee see eens calibrate. Connection hose (a)… 2… eee ee ee eee screw into first spark plug hole. Piston of cylinder to be tested …….. .+..e» rotate at crankshaft with setting device to ignition TDC (01-0120).
Note See table for pistons in TDC.
uti = RA 01,1214-0150/1
Gonnection hose (6a)… eee ee ee eee connect to tester (5). Compression chamber ………..0.000 00s pressurize (approx. 5 bar).
AN When doing this, do not rotate the crankshaft; if necessary, lock crankshaft in position to prevent it turning (03-5000). Throttle valve… 1… eee ee ee Lee eeeeees . open by hand. Pressure loss at tester (5) (in %) ………00read off. Determine whether the pressure escapes through intake manifold, exhaust, oil filler opening, spark plug hole of adjacent cylinder or through coolant opening. Allcylinders ….. see eee eee ree wee teen test in firing order (1–5–3–6–2~4).,
Data
Marking TDC b= 120°
Piston at TDC of cylinder Tand 6 2and 4 3 and §
>ylinder leak tester e.g. Bosch, EFAW 210A Sun, CLT 228
Note After spraying oil onto the piston crown, it is possible to determine whether the leak exists at the piston rings or at the valves, or at the cylinder head gasket.
tiie = RA 01.1214-0150/2


