Repairing spark plug threads

WIS 01-4070

Repairing spark plug threads – rysunek

Preceding work: Operation no. of operation texts and work units or standard texts Cylinder head cover removed (01-0500). and flat rates:

P01-5858–55

Piston of respective cylinder ………..0 0 . position to 20 ~ 30° BTDC. Grooves (arrows) of cornbination thread tap (9) of thread tapping unit 2.0… ee eee ee pack with grease. Stop ring (10) 1… ew ee ew eee ee sees pull off, fit on. Combination thread tap (9)… ee ee ee eee screw into damaged thread. Combination thread tap (9) 6.6… ee eee eee eee guide with guide bush (11) pushed into spark plug recess. Combination thread tap (9) «6.6… eee eee .. screw in sufficiently until guide tube (12) touches and is resting against the groove (arrow) on the guide bush (11).

a + With the cylinder installed, unscrew combination thread tap (9) after each 5 revolutions approximately, clean grooves of swarf and grease and re-pack with grease. Length of HELI-COIL threaded insert (8} ……. check. Use HELI-COIL insert (8) with 10.2 mm block length.

wth RA O1.1212—-4070/1

Repairing spark plug threads – rysunek
Repairing spark plug threads – rysunek

P01-5859–55

HELI-COIL threaded insert (8) ………..006 insert into fitting tools so that the stud (arrow) of the inset (8) is facing the pre-tensioning cartridge (16). HELI-COIL insert screw in flush (arrow) into pre-tensioning cartridge (16) using the spindle (13). Fitting tool fit onto tapped hole. Jacket sleeve (15) hold tight. Screw-in spindle (13) tum sufficiently until the stop ring (14) is resting against the jacket sleeve (15).

Note If jacket sleeve (15) jarns tight when screwing in, turn back slightly.

otis =RA 01.1212-4070/2

Repairing spark plug threads – rysunek
Repairing spark plug threads – rysunek

Sleeve (18) ……..-86. scene eee wee fit over driving stud (arrow). Driving stud (arrow) ow. ke ees fix in place with pliers (17) (serrations (s)). Sleeve (18) ……. we eee see ee eee eee turn to left as far a stop. PlierS (17) occ cece ee eee eee eee move up and down slightly, break off driving stud (arrow).

AN i driving stud drops onto the piston crown, it must be removed with a magnet. Degreased caulking tool (6) ……….. seen screw in and tighten to 25 Nim. Engine eee eee eee sec e tee eeneee crank with starter (01-0110) to remove any swarf which may have dropped onto the piston crown.

Repairing spark plug threads – rysunek

Special tools

oti RA 01.1212-4070/3