Removing and installing oi! pump

WIS 18-2100

Removing and installing oi! pump – rysunek

Preceding work: Operation no. of operation texts and work units or standard texts Oil sump removed (071-3100) and flat rates: 18-6020-6025

1 M& x 20 bolt 3 M6 x 25 bolt + washer

2 M& x 35 bolt + washer (hexagon socket) 4 Dowel sleeve

Bolt (1) of oil pump gear (6) 2… 0… 0.0004 unscrew, screw on (32 Nm). Oil pump drive gear (7) at oil pump (6) …….. pull off, fit on.

Note Install oil pump-drive gear (7) with convex face pointing toward oil pump (6) (arrows). Pay attention to position of tensioning bar relative to oil pump chain. Bolts + washer (2) and (3) ………0…0000. unscrew, screw on (M6. 9 Nm; M8 21 Nm).

whine = RA 18.1235-2100/4

Oil pump (6) «1.2.6.2… 2.08. see eee os rernove to the front, instail.

Note Fill oi] pump with engine oil before installing. Strainer in oil pump ………… see eee clean.

Removing and installing oi! pump – rysunek

Tightening torques iN Oil pump drive gear to oil pump 32

Removing and installing oi! pump – rysunek

Bolts to oil pump. cover (M6) 10

Note Oil pump with hollow gear shaft to prevent oil buzz after cold start up to about 2000 rpm. As of engine number (Novernber 1995) 104.941 10 006 361 104.941 12 068 532 104.942 10 006 914 104.942 12 062 914 104.943 10 001 343 104.943 12 005 453 104.945 10 000 014 104.945 12 000 024 104.991 12 017 802 104.992 10 005 537 104.995 12 100 782 104.995 12 010 421

oti §=RA 18.1235-2100/2