Sealing coolant pump

WIS 20-2250

Sealing coolant pump – rysunek

Preceding work: Operation no. of operation texts and work units or standard texts Coolant pump removed (20-2100). and flat rates:

13 M6 x 20 bolt + washer

Spiral housing (6) ……..-006 see see unbolt, bolt on (10 Nm). Ooting (7) occ cee eee een eens replace. Puller (14) 000 589 94 33 00 ………..508fit onto impeller (5). Jaws of puller (14)… seen see ee eee tension with sleeve inner dia. 40 mm (shop made) or suitable hosestrap. Impeller (5) 2… etn ence nee cee eaeee pull off. Mating ring B) 2… ccc ee eee pull off with pliers.

anh §=RA 20.1201-2250/1

Cassette-type seal (4) 0… eee eee eee press around circumference with screwdriver to remove from coolant pump (1).

Sealing coolant pump – rysunek

AN Do not damage coolant pump (1), use clean cloth as base.

Mount for cassette-type seal (4) clean.

Note Sealing cormpound is applied to the circumference of the cassette-type seal (4). New cassette-type seal (4) 2.2.0.0… ..008, press in with 40 mm diameter sleeve as far as the stop

otiin RA 20,1201-2250/2 fit onto purnp shaft with ground face toward Mating ring (8) sees eal (4a). Impeller (6)… see ee eee see heat to approx. 100 °C. Impeller (6)… eee eee eee cee press on. Size (a) (5.6–5.8 mm)

note. Tight seat of impeller (5) on pump shaft check.

Sealing coolant pump – rysunek

Special tool

ohhie = RA 20.1201-2250/3