Testing fuel evaporation control system

WIS 47-8201

Testing fuel evaporation control system – rysunek

Operation no. of operation texts and work units or standard texts and flat rates:

Location of components: models 107, 124, 126 and 201

36 50°C red thermovalve 52/4 Activated charcoal filter 107 {in front left

52 Activated charcoal filter, models 124, 126, 201 wheelhouse) (in front left wheelhouse) 53 Regeneration valve, models 107, 126, 201

wie RA 47.1142-8201/1

Testing fuel evaporation control system – rysunek

Location of components: models 107, 124, 126 and 201

51 Vent valve, model 107 51/8 Vent valve, models 124 Sedan, 126, 201 51/9 Vent valve, model 124 Station Wagon

wii §=RA 47.1142-8201/2

Testing fuel evaporation control system – rysunek

Location of components: model 129

36 70°C black thermovalve with white edging 52 Activated charcoal filter

51 Vent valve 53 Regeneration valve

Engine at operating temperature ………… approx. 80°C engine oil temperature. Special tool (018), 124 589 07 21 00. Regeneration valve (53 or 53/1) detach from black line to activated charcoal filter and slowly increase engine speed to approx. 3000/min. At idle speed, no extraction. Extraction occurs as engine speed rises. Thermovalve (36, in sensor block) ……….. check if passage blocked.

wim §=RA 47.1142-8201/3

Vacuum lines (white/black and white/violet/black) check that they are correctly connected at the throttle valve body and at thermovalve (36). Check condition. Vent valve (51, 51/8, 51/9) …………0… test operation. Connect tester 201 589 13 21 00 to connection fitting to fuel tank (pressure 30–50 mbar, vacuum 1–16 mbar). check from fuel tank via vent valve (51, 51/8, 51/9), activated charcoal filter (52, 52/4, remove bulkhead if necessary), regeneration valve (53) to throttle valve body (black) Activated charcoal filter (52, 52/4) ……….. check. The connections must be clear to each other.

Special tools

Testing fuel evaporation control system – rysunek
Testing fuel evaporation control system – rysunek

Repair note

@ Models 126, 201

Since 09/87 the housing of the activated charcoal filter has been made of plastic (previously sheet steel). When replacing parts, it is only permitted to replace like with like.

time =—RA 47.1142-8201/4

© Model 124

Testing fuel evaporation control system – rysunek

The regeneration valve (53/1) has been attached to the partition of the left component compartment since 09/87. The regeneration line runs from the activated charcoal filter through the engine components compartment to the regeneration valve and throttle valve body.

Testing fuel evaporation control system – rysunek

up to 08/1987 located at left wheelhouse

as of 09/1987 located at left partition

Notes

Models 107, 124, 126, 201

Fuel evaporation control system. Thermovalve for regeneration modified to 70°C (previously 50°C).

Production breakpoint: August 1987

Model Engine Engine end no. Engine end no. manual transmission automatic transmission

107.041 103.982 001571 006696

124.026 103.940 015305 031059

124.030/050/090 103.983 016764 085607

124.226 103.943 000091 000188

124.230/290 103.985 000400 001402

126.020 103.941 002786 008992

126.024/025 103.981 004674 038230

201.029 103.942 005709 008435

eile = RA 47.1142-8201/5

Model 124

Production breakpoint: March 1987

ModelVehicle ident end no.
124A 470552 F 036428

«ii )=—RA 47.1142-8201/6