Removing and installing fuel expansion tank, model 107

WIS 47-8021

Removing and installing fuel expansion tank, model 107 – rysunek

Operation no. of operation texts and work units or standard texts and flat rates: 47-8021.

Hardtop take off, fit on. Soft top open, close. Screws (59) unscrew, screw in (trunk side). Partition (57) remove, install.

Note Slacken trim in edge area, glue tight (MB universal adhesive 000 989 82 71). Battering cladding and battery (in trunk) remove, install. Wiring (64), vent lines (64/1) at fuel tank (50), fuel expansion tank (55) and below rear floor, take off, fit on.

wii RA 47.1142-8021/1

Vent lines (64/1) 2.0.2.0… 0.00. ..2020000. pull out through trunk floor, push through.

Installation note

Check wiring (64), vent lines (64/1) and securing clips for suitability for reuse (use only hose quality conforming to parts specifications). Screws (59) 2.2.2… 0… eee eee eee eee unscrew from soft top compartment side, screw in. Fuel expansion tank (55) ……………25. take out, insert.

Note

Model 107

Vent line (plastic pipe) from fuel expansion tank to vent valve shortened by 150 mm.

Production breakpoint: March 1988

ModelEngineVehicle ident end no. A
107.041103.982

whims §=RA 47.1142-8021/2