Checking basic position of camshaft

WIS 05-2230

Checking basic position of camshaft – rysunek

Preceding work: Cylinder head cover removed (01-0500).

Crankshaft rotate until TDC marking on vibration damper is aligned with TDC pointer (arrow). Setting hole (21) or setting pin in camshaft must be opposite cast marking (20) on first camshaft bearing bracket (arrow). Hole (4) (oval) with arrow (6) must be aligned with locating pin (3) in camshaft.

wii §=RA 05.1123-2230/1

Checking basic position of camshaft – rysunek

Special tool

Note

Checking basic position of camshaft – rysunek
Checking basic position of camshaft – rysunek

As of 12/1986 a setting hole (21) is provided in the camshaft in place of the pin (22).

Setting hole in place of setting pin, production breakpoint: 12/1986

Model Engine Engine end no. Vehicle ident end no. man. transm. autom. transm. A F

107.041 103.982 001053 004771 . . 124.026 103.940 010746 017151 . * 124.030 103.983 011713 058123 * . 124.090

126.020 103.941 001999 006594 * .

126.024 103.981 003433 027422 , * 201.029 103.942 000282 001635 * * . not recorded

ulm §=RA 05.1123-2230/2